Where is the abs sensor in a Mercedes Benz?

Answer by  rnovikoffgmailcom (1722)

The abs sensor is going to be on the abs breaks which will send a signal to show the little icon on the dash when the ABS system is actually being used

Answer by  Amber40 (24961)

The abs sensor should be located on each front wheel. It should be mounted somewhere on the suspension close to where the abs ring is on wheel. Look online or buy a repair manual for a detailed illustration.

Answer by  deepa (82)

Abs sensor location in a mercedes benz location change with its model. Simply call or e-mail phil for parts assistance. There should be four sensors are available on your mercedes benz vehicle

Answer by  Amber40 (24961)

The exact location will vary depending on the year and model. Typically it should be located right next to the brakes. It should be the only sensor in that area.

Answer by  Amber40 (24961)

Typically the abs sensor is mounted directly to the wheel hub. It reads the slotted ring mounted on the caliper to sense the speed of the wheel. Rear sensor usually mount point up from the bottom of the axle. Certain model will have the speed sensor mounted facing the ring attached to the half-shafts up front.

Answer by  sprintjapan (85)

What model and what year is it? The older models below year 1998 is located at the back side of the wheel hub. Its a wire looking thing with 1 end cylinder shape and 1 end like a socket

Answer by  mugabifred (26)

the sensors depend on the model, it should be located on the front wheel at the suspension near the abs ring on the wheel , they are supposed to be four , they measure the speed of the wheel which is then reflected on your dash board but the yaw rate sensor could be any where

Answer by  Amber40 (24961)

On most cars the abs sensor is located down at at wheel. There should be a notched ring mounted up against a sensor typically right behind the brake rotor. This is what measures the wheel speed.

Answer by  Allstar (2071)

There are several sensors in the ABS system; the yaw-rate sensor (which could be anywhere), the wheel speed sensors (on each wheel), and maybe a steering wheel angle sensor.

Answer by  basswulf89 (49)

its on the anti lock braking system attached to the wheel it also depends on what year and model of benz

Answer by  tkarlav (1502)

it should be either attached to the brake pad or or spindle of the vehicle depending on the model and year of car

Answer by  senthil34 (169)

For Model 163 vehicles,including the 2003 ML 350, ensure WIS document AR46. 10-P-0400GH is followed and adhered to when removing and installing the jacket tube.