How do I change fuel filters in a Jeep Cherokee?

Answer by  nicholas34 (606)

almost the same as any other car, you buy a new filter, take off the old one, and seal on the new one tightly

Answer by  JohnPants (140)

Fuel filters on the Jeep Cherokee are easy enough to change. If you look to the bottom left of the dip stick you'll see a plastic cover which will easily be released by pulling its handle. The filter is inside, and be sure to only replace it with an official Jeep filter.

Answer by  dee73 (1062)

You need to find out what side your fuel filter is located inside or outside of you tank.Then you need to pull the fuse and run your car till it shuts off. remove the filter and replace with new.

Answer by  Balance2 (66)

If your jeep has a fuel filter it could be located in a few places, either inside the fuel pump module in the gas tank or just in front of the fuel tank. Remove your fuel pump fuse and run the jeep until it stalls, then remove your fuel filter.

Answer by  Amber40 (24961)

It is pretty simple if you have a model with an inline fuel filter. You just disconnect the fuel line, unbolt the filter, and install the new one. If your Jeep uses an intake filter the tank will have to be removed and the new filter swapped in.

Answer by  palmerino (637)

the fuel lines will be on the frame, the filter is in the lines. Some cars use special tools for this job, ask the parts store guy about this.

Answer by  cgrid76hotmailcom (545)

There is one under the hood and there is one in the fuel tank .Do the one in the tank first because it is an easier

Answer by  worker8388 (994)

For replacing fuel filters we must remove fuel tank first. If its stalling remove the gas cap and wave it in air and put back. Drive it and check stalling.

Answer by  japratt (1687)

To replace the fuel filter on your Jeep Cherokee you will need to get under the hood. Once under the hood you need to take the new filter and replace it from the old.